How to protect the bathroom from moisture by a whole house furniture customization manufacturer?

　　Whole house furniture matchingHow can custom manufacturers teach everyone to protect bathrooms from moisture?

　　Custom manufacturers of whole house furniture tell you that when renovating a bathroom, waterproof and moisture-proof requirements should be considered from aspects such as wall and floor tile laying, ceiling treatment, pipe installation, and equipment selection, with careful planning.

　　When laying wall surfaces, floor tiles, and stones, a waterproof layer should be made under the surface layer. The ground should be leveled with cement mortar and coated with waterproof paint, then a layer of 1:2 cement mortar should be laid as a bonding layer, followed by floor tiles and other decorative materials. After watering, the floor tiles and other decorative materials should be compacted with wooden boards to ensure that the joints are flat and firm. Before laying stones, back coating should be done to reduce the occurrence of 'water damage'. The waterproof layer around the wall should be turned up, about 25 to 30 centimeters above the ground. The washbasin should be 1.0 to 1.2 meters above the ground, and the shower room should be 1.8 meters above the ground. If painting is done, waterproof putty should be applied, and waterproof paint should be chosen. The floor drainage should slope towards the floor drain, without water overflow or accumulation. A 24-hour water retention test should show no leakage. It is recommended to use micro-perforated aluminum ceiling panels to enhance ventilation and prevent condensation. If a gypsum board ceiling is made, waterproof putty should be applied first, followed by waterproof paint; PVC ceilings are prone to condensation and dripping, so use them with caution.

　　The editor of the custom manufacturer of whole house furniture reminds that when installing pipes, try to avoid changing the original exposed pipes. When renovation is needed, ensure that they are level and straight, laid firmly, and that the slope meets requirements. Valves and faucets should be installed in a straight position for flexible and convenient use. Exposed pipes should be painted with anti-rust paint, and concealed pipes should also be painted with anti-rust paint. The water supply pipes should be tightly connected to accessories and fixtures, and there should be no leakage during the water flow test. The design of the floor drain should primarily consider the drainage pipe, and the surface should be slightly lower than the ground.

　　The installation position of sanitary ware should be correct, with the upper edge of the fixtures being level. Bathroom electrical appliances should be from brands with good waterproof performance, such as bath warmers used in humid environments, which should have a corrosion-resistant stainless steel shell and be equipped with waterproof power switches, cables, and plugs. They should not be afraid of water splashes or drips when powered on or off, preventing leakage or damage, including waterproof lampshades and waterproof sockets.

　　Wooden materials should be avoided in bathrooms. If necessary, fireproof boards or fully mixed oil decorations should be used, which are waterproof. When decorating ceilings or other coverings, the hidden wooden keel should be coated with waterproof paint or preservatives.